Mount the rear case to a goose next using your preferred mounting technique. Global installers usually use #8 or #10 Self Tapping Tek Screws. Sometimes it is possible to use the 3 key shaped holes in the rear of the case, other times, due to the mount supplied by the goose neck, it is necessary to make new holes in the rear of the case for mounting. In either case, make sure any unused holes are sealed using silicon to prevent water, bugs and other elements from entering the case.
After all wires are connected and testing is complete, Global recommends a small bead of silicone be placed on the top 3 surfaces (even though there is a gasket this is an extra step to prevent intrusion).
!Warning
Be certain to properly ground the keypad and the goose neck (or other mounting provision) as shown in the Earth Grounding Section!
!Warning
Be certain to firmly attach the supplied ground wire from the Keypad face plate to the ground lug inside the rear case.
