×
Menu
Index

User Programmable Features

 
1.     Programmable Greeting [changeable a storagable list you can create!]
2.     User settable messaging including:
1.     Greeting
2.     Lockout
3.     Entry
4.     Exit
5.     Past Due
6.     Invalid Code
7.     Door Open
8.     More....
1.     Automatically open the gate after communication loss of x seconds [user programmable].  The setting is in Seconds and user settable from 0 to 254 where 0 is disabled.   Default setting is 0 (disable feature).
2.     Change the amount of time the user has to hold the touchpad button for it to be recognized.    To increase the debounce setting, raise this value.   This feature allows customization to suit your tenants needs – such as the elderly who may need more time.
3.     How long to wait for a response from the host;  displays no response from host after this timeout. 
4.     How long to wait for a user to finish putting their code in the touchpad ( and hit the Pound key).   This feature allows customization to suit your tenants needs – such as the elderly who may need more time.
5.     How often to check the gate monitor.  User settable from 2 to 254 seconds.  This optional feature allows the keypad to check the position of the gate and report it to the Axcys Software, so even if you cannot “see” the gate, you know if it is open, closed or in the middle.
    
 
Programmable Features:
 
Important
Some features available only on models shipped after 3/2009 – or having been re-programmed after 3/2009
 
The factory defaults for the three settings are:
If Modem:  RTS1 =30 RTS2= 90 and RTS3 = 25     'revised 5/4/10 from 30/30/25
If RS485: RTS1 = 0 RTS2= 90 and RTS3 = 5  (10 in the case of Muxes)
 
Use these in conjunction with Delay 1 for FSK Modem Communication settings.  Lowering
Delay1 Setting to 50 mS may help speed up and better communication with modems.
 
 
!Warning
Changing these settings can cause the unit to NEVER  respond!  Make changes in very small increments (like 1 or 2) and very carefully!  If communications are stopped, make the sum of RTS 1 and RTS2  greater than 150 then follow the steps below.
Next turn off the power to the KP, wait 10 seconds, then turn power back on.  This will force these settings back to the original factory settings.  You may also use the “Re-Start Device” command within DiagnostyX to perform a system re-start.  This will accomplish the same result.